Quantum DXi4700 User Manual page 327

Chapter 9: Configuration
System
4. Navigate back to the App Specific page (Configuration > System > App Specific). DAE will now
be enabled with a status of Running or Not Running (see
Figure 208: Application Environment - DAE Enabled
Note: If DAE is not running, refer to the Troubleshooting DAE section below.
Troubleshooting DAE
If you encounter problems when enabling the DAE feature, see the table below for troubleshooting steps:
Problem Corrective Action
System alerts Review any Admin Alerts (see
Tickets on page
System memory Depending on the current system configuration, additional memory may be required to run
DAE, or the additional memory was installed incorrectly.
Disable DAE
To disable DAE:
1. Clear the the Enable DAE check box (see
2. Click Apply.
A dialog box appears stating that the system will require a reboot. Click Yes. A reboot banner will
display during the reboot. Once the reboot is complete the login window will appear (see
the previous page).
Quantum DXi4700 User's Guide
Admin Alerts on page
183) that were generated when enabling DAE.
Figure 206 on the previous
Figure 208 below).
182) or Service Tickets (see
Contact Quantum
page)
Service
Figure 207 on
327