Quantum DXi4700 User Manual page 230

Chapter 9: Configuration
VTL Configuration
Targets
Use the Targets page to view the current target (Fibre Channel) configuration.
To access the Targets page, on the Host Access page, click the Targets tab (see
Figure 148: Targets Page
The Targets page displays the Target Port and WWPN for the currently configured targets. The
Backpanel Locations section displays a graphical representation of the Fibre Channel and Ethernet ports
as they appear on the rear of the system.
Note: A mapped (green) status indicates the host is currently logged on to one or more Fibre Channel
target ports.
Select one or more targets and click Reset Target(s) to initiate a Fibre Channel reset on the selected ports.
A reset causes the ports to go through LIP (Loop Initialization Protocol).
Target Usage
Use the Target Usage page to view current target and device mappings for the DXi4700.
To access the Target Usage page, on the Host Access page, click the Target Usage tab (see
on the next page).
Quantum DXi4700 User's Guide
Figure 148 below).
Figure 149
230