Quantum DXi4700 User Manual page 257

Chapter 9: Configuration
Replication Configuration
Additional Information
The Source IP field does not accept fully qualified domain names. You must enter a valid IP
l
address. Make sure this IP address is configured in the allowable sources list on the target DXi.
When configuring segmented network interfaces, if the source DXi replication, data, and
l
management interfaces are on the same subnet, you must add a host route on the source DXi to
make sure the replication interface is correctly selected when replicating data to the target DXi
(see Understanding Interface Routing on page
5. Click Apply.
Note: The new target is not automatically added to existing replication schedules. You must add or edit
scheduled events to schedule replication to the new target (see
Editing a Replication Target
Edit a replication target to change encryption options or the source IP address.
To edit a replication target:
1. Under Target DXis, select the target and click Pause to pause replication.
2. Select the target again and click Edit.
The Edit Target Host window displays (see
Note: If you are editing a target, you cannot change the Target Hostname or IP.
Figure 161: Edit Target Host
3. In the Encryption drop-down box, select the type of encryption to use when sending replication data to
the target system (None, 128-bit, 256-bit, or TLS with AES 256).
Important Information
AES encryption options are available only if the Data-in-Flight license is installed (see
l
Keys on page
Quantum DXi4700 User's Guide
349).
299).
Scheduler on page
Figure 161 below).
265).
License
257