Quantum DXi4700 User Manual page 303

Chapter 9: Configuration
System
Figure 188: Date & Time Page
To set the system date and time:
1. Select one of the following options:
Option
Network Time Protocol (NTP) Server
Manual Date & Time Settings
2. In the Timezone drop-down box, select the time zone where the DXi4700 is located.
3. Next to Time Format, select the format to use when displaying times (24 hours or 12 hours).
4. Click Apply.
Quantum DXi4700 User's Guide
Description
(Recommended) Select this option to synchronize the
DXi4700 with an NTP timeserver or pool. Then select or
specify a timeserver or pool.
Select a Timeserver Pool - (Recommended) Select
l
one of the well-known, geographically-based NTP
timeserver pools in the drop-down box.
Note: To select a timeserver pool, you must first
specify at least one DNS IP address on the
Network page (see
Otherwise, you must specify the IP address of the
timeserver pool.
Specify a Timeserver or Pool - Type the name or IP
l
address of the NTP server or pool. (See
http://support.ntp.org for information about publicly
available NTP servers)
To verify that the DXi4700 can communicate with the NTP
server or pool, click Test NTP.
Select this option to manually set the system date and time.
Specify the New System Date by clicking the calendar
icon. Specify the New System Time using the drop-down
boxes.
Network on page 290).
303