Quantum DXi4700 User Manual page 94

Chapter 4: Configuration Wizards
Replication Wizard
a. (Optional) Select the Enable Cartridge based replication to this DXi check box to enable
Cartridge Based Replication for the partition, and then enter a Sync ID in the box.
The Sync ID is used to identify the source partition that will send replicated data to the target
partition. The Sync ID must be identical to the Sync ID of the source partition on the source system.
b. If you enabled Cartridge Based Replication, select an Access option:
Access Option
Locked
Unlocked
Note: You cannot configure a partition to both send and receive Cartridge Based Replication
data.
4. Click Apply.
5. (Optional) To configure additional partitions for replication, repeat Steps 1–4.
6. Click Next to continue.
Figure 60: Replication Wizard: VTL Partitions
Step 4: Confirm
1. Review the settings you selected to make sure they are correct. If necessary, click Previous to return to
a previous step to make changes (see
2. After you have confirmed all settings, click Finish. The wizard configures the DXi4700 with the settings
you selected.
Quantum DXi4700 User's Guide
Description
The partition is not allowed to receive new Cartridge Based Replication data.
The partition is allowed to receive new Cartridge Based Replication data.
Figure 61 on the next page).
94