Quantum DXi4700 User Manual page 92

Chapter 4: Configuration Wizards
Replication Wizard
Note: Application Specific (RMAN) shares have Directory/File Based Replication enabled by
default. When an RMAN share is selected, this check box does not appear.
The Sync ID is used to identify the target share that will receive replicated data from the source
share. The Sync ID must be identical to the Sync ID of the target share on the target system.
c. Select the check box for each replication target you want to replicate the share to. When the share
is replicated, its data will be sent to all selected targets.
3. To configure the share to receive replicated data from another DXi system, enter the following
information under Receive:
a. (Optional) Select the Enable Directory/File based replication to this DXi check box to enable
Directory/File Based Replication for the share, and then enter a Sync ID in the box.
The Sync ID is used to identify the source share that will send replicated data to the target share.
The Sync ID must be identical to the Sync ID of the source share on the source system.
b. If you enabled Directory/File Based Replication, select an Access option:
Access Option
Locked
Unlocked
Note: You cannot configure a share to both send and receive Directory/File Based
Replication data.
4. Click Apply.
5. (Optional) To configure additional shares for replication, repeat Steps 1–4.
6. Click Next to continue.
Quantum DXi4700 User's Guide
Description
The share is not allowed to receive new Directory/File Based Replication data.
The share is allowed to receive new Directory/File Based Replication data.
92