Quantum DXi4700 User Manual page 298

Chapter 9: Configuration
System
Figure 186: Network Page: Routing Details
1. In the IP Address Table (above routing details), select an interface to add or modify routing data. (To
select an interface, click the radio button next to the interface index name, for example, bond0:2.)
After selecting an interface in the IP Address Table, the Routing Details table below expands to
display available routes (if any).
Note: A maximum of 8 routes per interface are allowed.
2. If necessary, click the Show link to show the routing details table.
3. Click Add Route to add a route to the selected interface.
Or select a route to edit its settings.
4. Enter the following network information as provided by your network administrator:
Destination
Dest Netmask
Dest Gateway
Additional Information
The destination gateway of each route must match the subnet of at least one configured IP
l
address listed in the IP Address Table. If no match is found, an error displays stating that the
route's destination gateway is not reachable.
In the example shown below, to reach a host on the 10.50.50.x subnet, you would enter
l
10.50.50.0 for destination network, 255.255.255.0 for the destination netmask, and 10.20.20.1 as
the destination gateway.
5. Click Update to save the changes you made to the Routing Details table. (Clicking Update does not
yet apply the new network settings to the DXi4700.)
6. Click Delete to remove IP routing information for the selected interface. Or click Undo to revert all
current Routing Details changes to the last update.
Quantum DXi4700 User's Guide
The destination network for the route.
The network mask for the route.
The gateway IP address used for outgoing traffic sent from the interface to a host or
client. (This is usually not the same as the default gateway.)
298