Ldap Parameters - AudioCodes Mediant 4000 SBC User Manual

Parameter
RADIUS VSA Access Level
Attribute
configure system > radius
settings > vsa-access-level
[RadiusVSAAccessAttribute]
RADIUS Servers Table
RADIUS Servers
configure system >
radius servers
[RadiusServers]
55.13.2.3

LDAP Parameters

The Lightweight Directory Access Protocol (LDAP) parameters are described in the table
below.
Parameter
LDAP Service
configure system > ldap settings >
ldap-service
[LDAPServiceEnable]
LDAP Authentication Filter
configure system > ldap settings >
auth-filter
[LDAPAuthFilter]
Use LDAP for Web > Telnet Login
configure system > ldap settings >
enable-mgmt-login
[MgmtLDAPLogin]
[LDAPDebugMode]
User's Manual
Defines the code that indicates the access level attribute in the Vendor
Specific Attributes (VSA) section of the received RADIUS packet.
The valid range is 0 to 255. The default is 35.
Defines RADIUS servers.
The format of the ini file table parameter is as follows:
[ RadiusServers ]
FORMAT RadiusServers_Index = RadiusServers_ServerGroup,
RadiusServers_IPAddress, RadiusServers_AuthenticationPort,
RadiusServers_AccountingPort, RadiusServers_SharedSecret;
[ \RadiusServers ]
For a detailed description of this table, see ''Configuring RADIUS
Servers'' on page 216.
Table 55-44: LDAP Parameters
Enables the LDAP feature.

[0] Disable (default)

[1] Enable
Note: For the parameter to take effect, a device reset is
required.
Defines the LDAP search filter attribute for searching the
login username in the directory's subtree for LDAP-based
user authentication and authorization.
You can use the dollar ($) sign to represent the username.
For example, if the parameter is set to
"(sAMAccountName=$)" and the user logs in with the
username "SueM", the LDAP query is run for
sAMAccountName=SueM.
Enables LDAP-based management-user login authentication
and authorization.

[0] Disable (default)

[1] Enable
Note: For the parameter to take effect, a device reset is
required.
Determines whether to enable the LDAP task debug
messages. This is used for providing debug information
regarding LDAP tasks.
The valid value range is 0 to 3. The default is 0.
820
Mediant 4000 SBC
Description
Description
Document #: LTRT-41729