AudioCodes Mediant 4000 SBC User Manual page 468

page 495.
Note: Call forking is not applicable to LDAP-based IP-to-IP routing rules.
The following procedure describes how to configure IP-to-IP routing rules through the Web
interface. You can also configure it through ini file (IP2IPRouting) or CLI (configure voip >
sbc routing ip2ip-routing).

To configure an IP-to-IP routing rule:
1. Open the IP-to-IP Routing table (Setup menu > Signaling & Media tab > SBC folder
> Routing > IP-to-IP Routing).
2. Click New; the following dialog box appears:
Figure 24-7: IP-to-IP Routing Table - Add Dialog Box
3. Configure an IP-to-IP routing rule according to the parameters described in the table
below.
4. Click Apply.
Table 24-3: IP-to-IP Routing Table Parameter Descriptions
Parameter
Routing Policy
sbc-routing-policy-name
[IP2IPRouting_RoutingPolicyName]
User's Manual
Description
Assigns a Routing Policy to the rule. The Routing Policy
associates the rule with an SRD(s). The Routing Policy
also defines default LCR settings as well as the LDAP
servers used if the routing rule is based on LDAP routing
(and Call Setup Rules).
468
Mediant 4000 SBC
Document #: LTRT-41729