User Information File; Enabling The User Info Table; User Information File For Sbc User Database - AudioCodes Mediant 4000 SBC User Manual

User's Manual
For example, the following checks whether the called prefix number 2000 is defined in
Dial Plan 1, which is used for obtaining the destination IP address (tag):
# debug auxilary-files dial-plan match-number PLAN1 2000
Match found for 4 digits
Matched prefix: 2000
Tag: 10.33.45.92

37.1.6 User Information File

This section describes the User Info table.

37.1.6.1 Enabling the User Info Table

Before you can use the User Info table, you need to enable the User Info functionality, as
described in the following procedure.

To enable the User Info table:
1. Make sure that your device's License Key provides far-end users support ("FEU"). To
view the License Key, see ''Viewing the License Key'' on page 582.
2. Open the Proxy & Registration page (Setup menu > Signaling & Media tab > SIP
Definitions folder > Proxy & Registration).
3. From the 'Enable User-Information Usage' drop-down list (EnableUserInfoUsage),
select Enable:
4. Reset the device with a save-to-flash for your settings to take effect; the User Info
table now appears in the Web interface.

37.1.6.2 User Information File for SBC User Database

You can use the SBC User Info table for the following:

Registering each user to an external registrar server.

Authenticating (for any SIP request and as a client) each user if challenged by an
external server.

Authenticating as a server incoming user requests (for SBC security).
If the device registers on behalf of users and the users do not perform registration, any SIP
request destined to the user is routed to the Proxy Set associated with the user's IP Group.
You can configure up to 3,000 users (table rows) in the SBC User Info table. The SBC
User Info table can be configured using any of the following methods:

Web interface - see ''Configuring SBC User Info Table through Web Interface'' on
page 578

CLI - see Configuring SBC User Info Table through CLI on page 579

Loadable User Info file - see ''Configuring SBC User Info Table in Loadable Text File''
on page 580
Version 7.2
Figure 37-2: Enabling User Info Table
577
37. Software Upgrade
Mediant 4000 SBC