AudioCodes Mediant 4000 SBC User Manual page 80

Note:
•
SNMP community strings are applicable only to SNMPv1 and SNMPv2c; SNMPv3
uses username-password authentication along with an encryption key (see
''Configuring SNMP V3 Users'' on page 84).
•
You can enhance security by configuring Trusted Managers (see ''Configuring
SNMP Trusted Managers'' on page 83). A Trusted Manager is an IP address from
which the SNMP agent accepts Get and Set requests.
For detailed descriptions of the SNMP parameters, see ''SNMP Parameters'' on page 721.

To configure SNMP community strings:
1. Open the SNMP Community Settings page (Setup menu > Administration tab >
SNMP folder > SNMP Community Settings).
2. Configure SNMP community strings for access privileges:
•
Under the Read Only Community Strings group, configure read-only
community strings (see the table below).
•
Under the Read/Write Community Strings group, configure read-write
community strings (see the table below).
3. Configure a community string for SNMP traps: Under the Misc. Settings group, in the
'Trap Community String' field, configure a community string (see the table below).
Figure 8-2: Configuring SNMP Trap Community String
4. Click Apply, and then reset the device with a save-to-flash for your settings to take
effect.
To delete a community string, delete the configured string, click Apply., and then reset the
device with a save-to-flash for your settings to take effect.
User's Manual 80
Mediant 4000 SBC
Document #: LTRT-41729