AudioCodes Mediant 4000 SBC User Manual page 340

5. Select the index row of the Proxy Set that you added, and then click the Proxy
Address link located below the table; the Proxy Address table opens.
6. Click New; the following dialog box appears:
Figure 17-10: Proxy Address Table - Add Dialog Box
7. Configure the address of the Proxy Set according to the parameters described in the
table below.
8. Click Apply.
Table 17-7: Proxy Sets Table and Proxy Address Table Parameter Description
Parameter
SRD
voip-network proxy-set > srd-
id
[ProxySet_SRDName]
General
Index
configure voip > voip-network
proxy-set
[ProxySet_Index]
Name
proxy-name
[ProxySet_ProxyName]
SBC IPv4 SIP Interface
sbcipv4-sip-int-name
[ProxySet_SBCIPv4SIPInterfa
ceName]
SBC IPv6 SIP Interface
sbcipv6-sip-int-name
[ProxySet_SBCIPv6SIPInterfa
ceName]
User's Manual
Assigns an SRD to the Proxy Set.
Note:

The parameter is mandatory and must be configured first before
you can configure the other parameters in the table.

To configure SRDs, see Configuring SRDs on page 309.
Defines an index number for the new table row.
Note: Each row must be configured with a unique index.
Defines an arbitrary name to easily identify the row.
The valid value is a string of up to 20 characters.
Note: Each row must be configured with a unique name.
Assigns an IPv4-based SIP Interface for SBC calls to the Proxy Set.
Note:

At least one SIP Interface must be assigned to the Proxy Set.

The parameter appears only if you have configured a network
interface with an IPv4 address in the IP Interfaces table (see
Configuring IP Network Interfaces on page 127).

To configure SIP Interfaces, see ''Configuring SIP Interfaces'' on
page 319.
Assigns an IPv6-based SIP Interface for SBC calls to the Proxy Set.
Note:

At least one SIP Interface must be assigned to the Proxy Set.

The parameter appears only if you have configured a network
interface with an IPv6 address in the IP Interfaces table.
340
Mediant 4000 SBC
Description
Document #: LTRT-41729