AudioCodes Mediant 4000 SBC User Manual page 670


To configure RADIUS accounting:
1. Open the Call Detail Record Settings page (Troubleshoot menu > Troubleshoot tab
> Call Detail Record folder > Call Detail Record Settings).
2. Configure the following parameters:
•
From the 'Enable RADIUS Access Control' drop-down list (EnableRADIUS),
select Enable.
•
From the 'RADIUS Accounting Type' drop-down list (RADIUSAccountingType),
select the stage of the call that RADIUS accounting messages are sent to the
RADIUS accounting server.
•
From the 'AAA Indications' drop-down list (AAAIndications), select whether you
want Authentication, Authorization and Accounting (AAA) indications.
For a detailed description of the parameters, see ''RADIUS Parameters'' on page 818.
3. Click Apply, and then reset the device with a save-to-flash for your settings to take
effect.
The table below lists the RADIUS Accounting CDR attributes included in the
communication packets transmitted between the device and a RADIUS server.
Table 49-6: Supported RADIUS Accounting CDR Attributes
Attribute Attribute
ID Name
Request Attributes
1 user-name
4 nas-ip-address (Standard) IP address of the
6 service-type
26 h323-
incoming-conf-
id
26 h323-remote-
address
User's Manual
Figure 49-14: Configuring RADIUS Accounting
Vendor-
Specific
Description
Attribute
(VSA) ID
(Standard) Account number or
calling party
number or blank
requesting device
(Standard) Type of service
requested
1 SIP call identifier
23 IP address of the
remote gateway
670
Mediant 4000 SBC
Value
Example
Format
String 5421385747
up to 15
digits
long
Numeric 192.168.14.43
Numeric 1: login
Up to h323-incoming-
32 conf-id=38393530
octets
Numeric -
Document #: LTRT-41729
AAA
Start
Acc
Stop
Acc
Start
Acc
Stop
Acc
Start
Acc
Stop
Acc
Start
Acc
Stop
Acc
Stop
Acc