Site Assessment & Gate Design For Monitored Entrapment - HySecurity UL 325 Quick Start - Supplemental Instructions

S a
Ite SSeSSment
Eye Open
NOTE: Any gap larger than 2¼" (57 mm) between gate and fixed objects must be
protected. Install edge sensors where gap between post and gate creates a draw-in zone.
Slide Gate: Monitored Entrapment Site Scenario (Viewing from SECURE side)
Slide Gate: Monitored Entrapment Site Scenario (Viewing from PUBLIC side)
NOTICE: UL 325 Standard of Safety provides the MINIMUM safety standards. Site, gate hardware usage,
and other conditions may dictate the use of additional safety designs/components. It is up to the gate system
designer and installer to assess appropriate safety design and components above and beyond minimum
UL 325 and ASTM F2200 standards. Always check your local area codes and comply with all regulations.
16
D0726 Rev. J
& G d
ate
Check gap & protect
potential draw-in zones
SECURE
PUBLIC
UL 325 - 2016 HySecurity Monitored Sensors
m
eSIGn for onItored
Edge Open
Eye Close
e
ntrapment
PUBLIC
Eye Close
SECURE
© 2016 www.hysecurity.com