Resource Allocation Indication Parameters - AudioCodes Mediant 800B User Manual

Parameter

51.3.4 Resource Allocation Indication Parameters

The Resource Allocation Indication (RAI) parameters are described in the table below.
Parameter
[EnableRAI]
[RAIHighThreshold]
[RAILowThreshold]
[RAILoopTime]
User's Manual
Note: For a detailed description of this table, see 'Filtering Syslog
Messages and Debug Recordings' on page 616.
Table ‎ 5 1-18: RAI Parameters
Enables RAI alarm generation if the device's busy endpoints exceed a
user-defined threshold.

[0] = (Default) Disable RAI (Resource Available Indication) service.

[1] = RAI service enabled and an SNMP
'acBoardCallResourcesAlarm' Alarm Trap is sent.
Defines the high threshold percentage of total calls that are active (busy
endpoints). When the percentage of the device's busy endpoints
exceeds this high threshold, the device sends the SNMP
acBoardCallResourcesAlarm alarm trap with a 'major' alarm status.
The range is 0 to 100. The default is 90.
Note: The percentage of busy endpoints is calculated by dividing the
number of busy endpoints by the total number of "enabled" endpoints
(trunks are physically connected and synchronized with no alarms and
endpoints are defined in the Trunk Group Table).
Defines the low threshold percentage of total calls that are active (busy
endpoints).
When the percentage of the device's busy endpoints falls below this low
threshold, the device sends an SNMP acBoardCallResourcesAlarm
alarm trap with a 'cleared' alarm status.
The range is 0 to 100%. The default is 90%.
Defines the time interval (in seconds) that the device periodically checks
call resource availability.
The valid range is 1 to 200. The default is 10.
664
Mediant 800B GW & E-SBC
Description
Description
Document #: LTRT-10274