Multiple Voip Network Interfaces And Vlan Parameters; Routing Parameters - AudioCodes Mediant 500 E-SBC User Manual

User's Manual

53.2.2 Multiple VoIP Network Interfaces and VLAN Parameters

The IP network interfaces and VLAN parameters are described in the table below.
Table 53-10: IP Network Interfaces and VLAN Parameters
Parameter
Interface Table
Web: Interface Table
EMS: IP Interface Settings
CLI: configure voip >
interface network-if display
[InterfaceTable]
[EnableNTPasOAM]

53.2.3 Routing Parameters

The IP network routing parameters are described in the table below.
Parameter
Web: Send ICMP
Unreachable Messages
[DisableICMPUnreachable]
Web: Send and Receive
ICMP Redirect Messages
[DisableICMPRedirects]
Static Route Table
Web/EMS: Static Route
Table
CLI: configure voip > static
[StaticRouteTable]
Version 6.8
This table parameter configures the Interface table.
The format of the ini file table parameter is as follows:
[InterfaceTable]
FORMAT InterfaceTable_Index = InterfaceTable_ApplicationTypes,
InterfaceTable_InterfaceMode, InterfaceTable_IPAddress,
InterfaceTable_PrefixLength, InterfaceTable_Gateway,
InterfaceTable_VlanID, InterfaceTable_InterfaceName,
InterfaceTable_PrimaryDNSServerIPAddress,
InterfaceTable_SecondaryDNSServerIPAddress,
InterfaceTable_UnderlyingDevice;
[\InterfaceTable]
For a detailed description of this table, see ''Configuring IP Network
Interfaces'' on page 113.
Note: For this parameter to take effect, a device reset is required.
Defines the application type for Network Time Protocol (NTP) services.

[1] = OAMP (default)

[0] = Control
Note: For this parameter to take effect, a device reset is required.
Table 53-11: IP Network Routing Parameters
Enables sending of ICMP Unreachable messages.

[0] Enable = (Default) Device sends these messages.

[1] Disable = Device does not send these messages.
Enables sending and receiving of ICMP Redirect messages.

[0] Enable = (Default) Device sends and accepts these messages.

[1] Disable = Device rejects these messages and also does not send
them.
Defines up to 30 static IP routes for the device.
The format of the ini file table parameter is as follows:
[ StaticRouteTable ]
FORMAT StaticRouteTable_Index = StaticRouteTable_DeviceName,
StaticRouteTable_Destination, StaticRouteTable_PrefixLength,
StaticRouteTable_Gateway, StaticRouteTable_Description;
687
53. Configuration Parameters Reference
Description
Description
Mediant 500 E-SBC