Enabling Syslog; Configuring The Syslog Server Address - AudioCodes Mediant 500L User Manual

ITU Perceived Severity
(SNMP Alarm's Severity)
Critical
Major
Minor
Warning
Indeterminate
Cleared

Cleared Alarms: CLEAR-ALARM: <Alarm Name>; Textual Description: <Textual
Description>; Severity <Alarm Severity>; Source <Alarm Source>; Unique ID: <Alarm
Unique ID >; If exists Additional Info1:/ Additional Info2:/ Additional Info3:

60.2.2 Enabling Syslog

The following procedure describes how to enable Syslog.

To enable Syslog:
1. Open the Syslog Settings page (Troubleshoot menu > Troubleshoot tab > Logging
folder > Syslog Settings).
2. From the 'Enable Syslog' drop-down list, select Enable.
3. Click Apply.

60.2.3 Configuring the Syslog Server Address

The following procedure describes how to configure the Syslog server's address to where
the device sends Syslog messages.

To configure the Syslog server address:
1. Open the Syslog Settings page (Troubleshoot menu > Troubleshoot tab > Logging
folder > Syslog Settings).
2. In the 'Syslog Server IP' field (SyslogServerIP), enter the IP address of the Syslog
server.
3. In the 'Syslog Server Port' field, enter the port of the Syslog server.
Figure 60-3: Configuring the Syslog Server Address
User's Manual
Table 60-6: Syslog Message Severity
RecoverableMsg
RecoverableMsg
RecoverableMsg
Notice
Notice
Notice
Figure 60-2: Enabling Syslog
964
Mediant 500L Gateway & E-SBC
AudioCodes' Syslog Severity
Document #: LTRT-10532