Lithopattern, Gobo, And Effect Installation; Locating The Litho/Effect Wheels - High End Systems studio spot User Manual

LithoPattern, Gobo, and Effect Installation

To install LithoPatterns, gobos, or effects, complete the following procedure:
1. Remove power from the fixture and place it upright on a flat surface.
2. Remove the bezel by releasing the two latches located in the middle of the
fixture head. Refer to Figure B.1.
3. Remove the safety cable from its latch and set the bezel aside.
4. Locate the litho wheels. Refer to Figure B-9.
litho wheel 1
5. Rotate the desired wheel to the litho or effect you want to replace. Take
note of the positions in relation to the tabs. Refer to Figure B-10.
Figure B-9. Locating the Litho/Effect Wheels
1
2
3
tab
Figure B-10. Factory Litho Wheel Positions
litho wheel 2
6
5
4
Appendix B Accessory Installation B-7