Remote Display Adjustment; Remote Homing - High End Systems studio spot User Manual

Remote Display Adjustment

You can remotely adjust the intensity of the display via DMX.
To set the display's intensity, complete the following procedure:
1. Set DMX channel 20 (Shutter) to a value of 0 on the appropriate
fixture(s). This will unlock the channel 24 (Control channel).
2. Set DMX channel 24 (Control) to the desired value for at least one
second:
• Off: 20-28
• Dim: 30-38
• Bright: 40-48
3. Set DMX channel 20 to a value other than 0.
4. Set DMX channel 24 to 0 (safe).
Note: to manually adjust the display intensity (using the front panel), refer to
"Setting Display Intensity" on page 3-25.

Remote Homing

Homing is the process of recalibrating the fixture's mechanical positions. This
ensures that fixtures attain the correct positions from DMX data.
To remotely home a fixture, complete the following procedure:
1. Set DMX channel 20 (Shutter) to a value of 0 on the appropriate
fixture(s). This will unlock the channel 24 (Control channel).
2. Set DMX Channel 24 (Control) to 60-68 for at approximately one
second. The display will indicate
off, and the display will indicate
After the fixture has homed, it will return to its programmed position.
3. Set DMX channel 20 to any value other than 0.
4. Set DMX channel 24 to 0 (safe).
Note: to manually home the fixture (using the front panel), refer to "Homing
the Fixture" on page 3-21.
2-12 Studio Spot User's Manual
(reset), strike the lamp if it is
R S T
while all motor systems reset.
H O M E