Removing The Securing Spring - High End Systems studio spot User Manual

6. Locate the spring securing the litho or effect to the wheel. Pull the spring
tip towards the center of the aperture. Refer to Figure B-11. The spring
will release from its groove inside the aperture.
7. Remove the spring and litho/effect from the aperture.
8. Place the new litho, effect, or gobo into the aperture and replace the
spring. If you are installing a litho, insert it with the coated side away from
the lamp. To determine the coated side, refer to Figure B-8. However, if
you are installing an effect, insert it with the smooth side towards the
wheel.
Caution: improper installation is likely to cause lithos to fail.
9. Replace the bezel, secure the safety cable to its clamp, and relatch the
bezel.
Note: the bezel can only be replaced one way to ensure the safety cable can
connect to its bracket.
B-8 Studio Spot User's Manual
Figure B-11. Removing the Securing Spring
spring tip