Powering On The Fixture; Setting The Fixture Address; Fixture Number Mode - High End Systems studio spot User Manual

Powering On the Fixture

To power on the fixture, complete the following procedure:
1. Connect AC mains (power) to the fixture.
2. Turn on the breaker located next to the line cord on the side of the fixture.
Refer to Figure 1.9. The fixture will home.
Notes: if any error messages are present on the display, refer to Troubleshooting
in Appendix A. If the fixture was left in preset playback mode, indicated
by cycling P R S T on the display and a dot in the lower right of the
display, the fixture will begin playback of the preset scenes.
Tip: to skip the homing process, simultaneously hold down the <
< > buttons immediately after applying power to the fixture.
ENTER

Setting the Fixture Address

Use the following subsections to set the fixture address. Fixtures may be
addressed by fixture number (1-21) or by DMX starting channel number (1-489).
Either way, each fixture uses 24 DMX channels.

Fixture Number Mode

To address Studio Spot by fixture number, complete the following procedure:
1. Apply power to the fixture.
2. Observe the display on the front of the fixture. Initially, it will display
S P O T , the software version (V xxx), and then the fixture number
(F 0 1 ). Refer to Figure 1.11.
3. Press and hold <
<
ENTER
1-10 Studio Spot User's Manual
Figure 1.11 Using the Front Panel
> until the display changes to A d d R . Press
MENU
> to manipulate the address field.
> and
MENU