Playing Back Scenes In Stand-Alone Mode; Determining The Active Scene - High End Systems studio spot User Manual

Playing Back Scenes in Stand-Alone Mode

Scenes can be played back on each fixture without a controller through
the menu system.
Note: if a fixture is connected to a DMX link, the fixture will not respond
to data while it is in playback mode.
To playback scenes in stand-alone mode, complete the following
procedure:
1. Press and hold <
necessary).
2. Using the up and down arrow buttons, scroll to the P R S T field and
press <
3. Using the up and down arrow buttons, scroll to the P L A Y field and
press <
4. Using the up and down arrow buttons, scroll to the O N field and press
<
ENTER
hand corner to indicate you are in playback mode and the programmed
scenes will begin playback. When playback finishes playing scene 16 or it
comes to the first blank scene, the sequence will loop and restart at
scene 1.

Determining the Active Scene

To determine the active scene during playback, complete the following
procedure:
1. Press and hold <
necessary).
2. Using the up and down arrow buttons, scroll to the P R S T field and
press <
3. Using the up and down arrow buttons, scroll to the P L A Y field and
press <
4. Using the up and down arrow buttons, scroll to the S C N field and press
<
ENTER
4-8 Studio Spot User's Manual
> until the fixture unlocks the menu system (if
MENU
>.
ENTER
>. O F F will appear on the display.
ENTER
>. The display will indicate P R S T with a dot in the lower right-
> until the fixture unlocks the menu system (if
MENU
>.
ENTER
>. O F F will appear on the display.
ENTER
>. The display will indicate the scene that is playing.