Chapter 1
Installation and Setup
In this chapter you will:
unpack the fixture (1-1)
register your fixture (1-2)
construct a road case (1-3)
construct a line cord cap (1-5)
learn the power requirements (1-6)
construct a data cable (1-6)
construct a terminator (1-7)
mount the fixture (1-7)
connect data cables (1-9)
power on the fixture (1-10)
address the fixture (1-10)
control the fixture with DMX 512 (1-12)
Unpacking Studio Spot
In this section you will unpack your Studio Spot and verify that it arrived
complete and without any damage.
Save the shipping materials. Do not discard the shipping carton and packing
materials. The carton and packing materials are specifically designed to
protect the fixture during transport.
If you ever need to return a product for repair or maintenance, you must
return it in its original shipping carton and packing materials. If you return
your Studio Spot in a non-factory shipping carton or non-factory packing
materials, you will be billed for the materials.
Note: before returning anything to the factory, be sure to call your High End
Systems Dealer/Distributor for a Return Material Authorization Number.
The High End Systems cannot accept any goods shipped without an RMA
number. Refer to "Acquiring Technical Support" on page A-2.
Inspecting the Contents
The shipping carton contains the following items:
• Studio Spot fixture
• Philips MSR 575/2 lamp installed in the fixture
• Studio Spot User's Manual
• Studio Spot Quick Reference Card
Chapter 1 Installation and Setup
1-1