Installing The Lamp - High End Systems studio spot User Manual

lamp socket
lamp cap
4. Holding the new lamp by its base, align the base pins to the socket and
carefully push the lamp into the socket. Refer to Figure A.2.
Warning: do not touch the lamp with bare fingers. The oils from your skin can
damage the lamp and cause it to explode. If the lamp is accidentally
touched, clean it immediately with a soft cloth and isopropyl alcohol
((CH ) CHOH). An alcohol cloth is provided with each lamp.
3 2
5. Place lamp assembly back into the housing and tighten the hex screws.
Caution: do not overtighten the hex screws.
Notes: when a lamp is replaced, remember to reset the lamp hours as outlined in
"Resetting Lamp Hours" on page 3-18 and optimize the lamp as outlined
in "Optimizing the Lamp" on page A-12.
lamp glass
base pins
ceramic base
Figure A.2. Installing the Lamp
Appendix A Troubleshooting and Maintenance A-11
2