Road Cases; Minimum Material Requirements; Construction Requirements; Road Case Construction Overhead View - High End Systems studio spot User Manual

Road Cases

If Studio Spot fixtures will be transported after they are unpacked from
their original shipping box, a professional road case is strongly
recommended. Road cases can be purchased from High End Systems or
constructed in accordance to the information in this section.

Minimum Material Requirements

Use the following materials to construct the road case:
• 3/4-inch pressed plywood
• 4 pound polyethylene foam
• steel or aluminum rivets

Construction Requirements

The road case must be constructed in a manner that supports the base and
the handles with the head pointed down and the yoke rotated 90°. Refer to
Figure 1.2 and Figure 1.3.
Caution: allow a small gap in the foam around the heat sink to ensure that the
foam is not damaged by the heat from the fixture.
foam
Figure 1.2 Road Case Construction Overhead View
case exterior
fixture base
Chapter 1 Installation and Setup 1-3