High End Systems studio spot User Manual page 108

Display
Message
flash ROM could
E R S E
not be erased dur-
F L S H
ing an upload
Field Programmable
F P G A
Gate Array error
E R R
ID or unique num-
I d
ber error
E R R
lamp has extin-
L A M P
guished during
O U T
operation
E R R
lamp time-out error
L A M P
T O U T
E R R
other data present
L I N K
on the link during a
b U S Y
crossload
no fixtures were
L I N K
found to crossload
E M T Y
to
link error
L I N K
E R R
logic board is over
O V E R
rated its tempera-
T E M P
ture
A-4 Studio Spot User's Manual
Table A.1: Display Error Messages (Continued)
Problem
• bad flash ROM
• read/write error from
FPGA
• error reading ID
• error reading unique
fixture number
• dead lamp
• lamp too hot to restrike
• dead lamp
• ignitor error
• controller is connected
to the link
• additional Studio Spot
fixtures are not
connected to the
master during a
crossload
• bad cable(s)
• output from previous
fixture is bad
• bad comm board
• temperature exceeds
limit for safe operation
and the board has
shutdown
Explanation Solution
• refer to qualified
service personnel
• refer to qualified
service personnel
• refer to qualified
service personnel
• replace lamp, refer to
"Replacing the
Lamp" on page A-10
• allow time for the
lamp to cool and
restrike the lamp
• replace lamp, refer to
"Replacing the
Lamp" on page A-10
• refer to qualified
service personnel
• disconnect
controller
• connect additional
fixtures
• check cabling
• test and replace
cable(s) as necessary
• test by bypassing
previous fixture
• refer to qualified
service personnel
• reduce ambient
temperature and
move significant
heat sources
• refer to qualified
service personnel