Lens Installation; Removing The Bezel - High End Systems studio spot User Manual

Lens Installation

Studio Spot offers three lenses to accommodate all applications. To
determine the lens that best suits your application, refer to "Calculating
Beam Diameters" on page C-6.
To install an accessory lens, complete the following procedure:
1. Remove power from the fixture and place it upright on a flat surface.
2. Remove the bezel by releasing the two latches located in the middle of the
head. Refer to Figure B.1.
3. Remove the safety cable from its latch and set the bezel on a flat surface.
4. Loosen the thumb screw which holds the lens ring in place and pivot the
ring away from the lens. Refer to Figure B-2.
B-2 Studio Spot User's Manual
latch
Figure B.1. Removing the Bezel
Figure B-2. Loosening the Lens Ring Thumb-Screw
latch
thumb screw