Truss Mounting - High End Systems studio spot User Manual

Truss Mounting

Studio Spot can be mounted in any orientation on 22-inch centers. To mount
the fixture on a truss, you will need the following equipment:
• (2) safety cables
• (2) Cheeseborough clamps (recommended) or other mounting hardware
Complete the following procedure to mount the fixture to a truss:
1. Lay the fixture on its side and attach the mounting hardware the center
holes on the base. Refer to Figure 1.7.
2. Install the fixture on the truss and secure the mounting hardware.
3. Connect the safety cable ends by looping the cable over the truss,
running it through an outer hole on the base of the fixture, around the
handle, and out the other outer hole. Refer to Figure 1.8. Repeat this
step to install another safety cable on the other side of the fixture.
Caution: do not place safety cables through the lower plate that connects to the
fixture yoke. Doing so may cause interference with the fixture's pan
movement.
1-8 Studio Spot User's Manual
center holes
Figure 1.7 Attaching Mounting Hardware
ETL Listed
Conforms to
ANSI/UL-1572
Certified to CAN/CSA
c
C22.2 No. 9
®
Dry Locations Only
67501
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interferences, and
(2) this device must accept any interference that may cause
undesired operation.
Figure 1.8 Safety Cable Installation
®
99410036