Address Menu; Addressing The Fixture; Information Menu; Viewing Lamp Status - High End Systems studio spot User Manual

Address Menu

Use the following subsection to use the A d d R menu.

Addressing the Fixture

Studio Spot can be addressed by fixture number or DMX starting channel. To
change the way Studio Spot is addressed, refer to "Addressing By DMX
Starting Channel or Fixture Number Mode" on page 3-24.
To address Studio Spot, complete the following procedure:
1. Observe the display. Initially, it will display S P O T , the software
version (V x x x ), and then the fixture number (F 0 1 - F 2 1 ) or the
DMX starting channel (C 0 0 1 - C 4 8 9 ).
2. Press and hold <
3. Press <
4. Using the up and down arrow buttons, set the desired fixture number
or address. The display will flash when it is moved from the existing
value.
5. Press <
The display will stop flashing.
Note: if the <
address.

Information Menu

Use the following subsections to use the functions contained within the
I N F O menu.

Viewing Lamp Status

To view the lamp status, complete the following procedure:
1. Hold <
2. Using the up and down buttons, scroll to the I N F O field and press
<
ENTER
3. Press <
of the following:
• O N - the lamp is on
• O F F - the lamp is off
• S T R K - the lamp is attempting to strike
3-16 Studio Spot User's Manual
> until the display changes to A d d R .
MENU
> to edit the A d d R field.
ENTER
> to store the desired fixture number or DMX channel.
ENTER
> key is not pressed, the fixture will not store the
ENTER
> until the display changes to A d d R .
MENU
>. The display will indicate L A M P .
> to view the lamp status. The fixture will display one
ENTER