Replacing The Lens - High End Systems studio spot User Manual

5. Remove the lens from the assembly and set it aside.
6. Align the lip of the new lens with the ring and slide it into the assembly.
Refer to Figure B-3.
7. Pivot the ring back to secure the lens to its assembly and retighten the
thumb screw.
8. Replace the bezel, attach the safety cable, and secure its latches.
Note: the bezel can only be correctly replaced one way to allow the use of the
safety cable.
Figure B-3. Replacing the Lens
lip
Appendix B Accessory Installation B-3