Power Supply - Endress+Hauser Proline Prosonic Flow B 200 Operating Instructions Manual

Technical data
Load
Low flow cut off
Galvanic isolation
Protocol-specific data
Terminal assignment
Supply voltage
134
Frequency output
Failure mode
Switch output
Failure mode
Local display
Plain text display With information on cause and remedial measures
Backlight Additionally for device version with SD03 local display: red lighting indicates a
device error.
Status signal as per NAMUR recommendation NE 107
Operating tool
• Via digital communication:
HART protocol
• Via service interface
Plain text display With information on cause and remedial measures
→  26
The switch points for low flow cut off are user-selectable.
All outputs are galvanically isolated from one another.
HART
• For information on the device description files →  52
• For information on the dynamic variables and measured variables (HART device
variables) →  52
16.5

Power supply

→  25
Transmitter
An external power supply is required for each output.
The following supply voltage values apply for the outputs available:
Choose from:
• Actual value
• 0 Hz
• Defined value: 0 to 1 250 Hz
Choose from:
• Current status
• Open
• Closed
Proline Prosonic Flow B 200 HART
Endress+Hauser