Endress+Hauser Proline Prosonic Flow B 200 Operating Instructions Manual page 83

Proline Prosonic Flow B 200 HART
Parameter
Assign process variable
On value low flow cutoff
Off value low flow cutoff
* Visibility depends on order options or device settings
Endress+Hauser
Parameter overview with brief description
Prerequsite
–
One of the following options is
selected in the Assign process
variable parameter (→  83):
• Volume flow
• Corrected volume flow
• Corrected methane volume
*
flow
• Mass flow
*
• Energy flow
• Flow velocity
One of the following options is
selected in the Assign process
variable parameter (→  83):
• Volume flow
• Corrected volume flow
• Corrected methane volume
*
flow
• Mass flow
*
• Energy flow
• Flow velocity
Description
Select process variable for low
flow cut off.
Enter on value for low flow cut
off.
Enter off value for low flow cut
off.
Commissioning
Selection / User Factory setting
entry
• Off Off
• Volume flow
• Corrected volume
flow
• Corrected methane
*
volume flow
• Mass flow
*
• Energy flow
• Flow velocity
Positive floating- Depends on country
point number and nominal
diameter
0 to 100.0 % 50 %
83