Endress+Hauser Proline Prosonic Flow B 200 Operating Instructions Manual page 28

Electrical connection
28
7.
WARNING
L
Housing degree of protection may be voided due to insufficient sealing of the
housing.
‣
Screw in the screw without using any lubricant. The threads on the cover are
coated with a dry lubricant.
Reverse the removal procedure to reassemble the transmitter.
Removing a cable
mm (in)
‣
To remove a cable from the terminal, use a flat-blade screwdriver to push the slot
between the two terminal holes while simultaneously pulling the cable end out of the
terminal.
7.2.2 Ensuring potential equalization
Requirements
No special measures for potential equalization are required.
For devices intended for use in hazardous locations, please observe the guidelines in
the Ex documentation (XA).
Proline Prosonic Flow B 200 HART
3 (0.12)
3 4 1 2
A0013835
Endress+Hauser