Endress+Hauser Proline Prosonic Flow B 200 Operating Instructions Manual page 22

Installation
22
8 mm
1. Release the fixing screw.
2. Turn the housing to the desired position.
3. Firmly tighten the securing screw.
6.2.5 Turning the display module
The display module can be turned to optimize display readability and operability.
1. Loosen the securing clamp of the electronics compartment cover using an Allen key.
2. Unscrew cover of the electronics compartment from the transmitter housing.
3. Optional: pull out the display module with a gentle rotational movement.
4. Rotate the display module into the desired position: Max. 8 × 45° in each direction.
5. Without display module pulled out:
Allow display module to engage at desired position.
6. With display module pulled out:
Feed the cable into the gap between the housing and main electronics module and
plug the display module into the electronics compartment until it engages.
7. Reverse the removal procedure to reassemble the transmitter.
Proline Prosonic Flow B 200 HART
max. 350°
8 mm
1
3 mm
Endress+Hauser
A0013713
A0013905