Endress+Hauser Proline Prosonic Flow B 200 Operating Instructions Manual page 95

Proline Prosonic Flow B 200 HART
Endress+Hauser
parameters automatically after 60 s if the user skips back to the operational display mode
from the navigation and editing view.
• If write access is activated via access code, it can be also be deactivated only via the
access code →  46.
• The user role with which the user is currently logged on via the local display
→  46 is indicated by the Access status display parameter. Navigation path:
"Operation" menu → Access status display
Parameters which can always be modified via the local display
Certain parameters that do not affect the measurement are excepted from write protection
via the local display. Despite the defined access code, these parameters can always be
modified even if the other parameters are locked.
Language
10.8.2 Write protection via write protection switch
Unlike write protection via a user-specific access code, this allows write access to the entire
operating menu - other than the "Contrast display" parameter - to be locked.
The parameter values are now read only and cannot be edited any more (exception
"Contrast display" parameter):
• Via local display
• Via service interface (CDI)
• Via HART protocol
1. Loosen the securing clamp.
2. Unscrew the electronics compartment cover.
Parameters for configuring
the local display
↓
Format display
Contrast display
Display interval
OFF
ON
CDI WP
XXXXXXXXXXXXX
Commissioning
Parameters for configuring
the totalizer
↓
Control Totalizer
Preset value
Reset all totalizers
3 mm
A0025794
95