Endress+Hauser Proline Prosonic Flow B 200 Operating Instructions Manual page 68

Commissioning
Parameter
Failure mode
Failure current
* Visibility depends on order options or device settings
68
Prerequsite
One of the following options is
selected in the Assign current
output parameter (→  67):
• Mass flow
• Volume flow
• Corrected volume flow
• Corrected methane volume
*
flow
• Temperature
*
• Energy flow
*
• Methane fraction
*
• Calorific value
*
• Wobbe index
• Sound velocity
• Flow velocity
*
• Acceptance rate
*
• Signal asymmetry
*
• Turbulence
*
• Signal strength
*
• Signal to noise ratio
One of the following options is
selected in the Current span
parameter (→  67):
• 4...20 mA NAMUR
• 4...20 mA US
• 4...20 mA
The Defined value option is
selected in the Failure mode
parameter.
10.4.6 Configuring the pulse/frequency/switch output
The Pulse/frequency/switch output wizard guides you systematically through all the
parameters that can be set for configuring the selected output type.
Description
Define output behavior in
alarm condition.
Enter current output value in
alarm condition.
Proline Prosonic Flow B 200 HART
Selection / User Factory setting
entry
• Min. Max.
• Max.
• Last valid value
• Actual value
• Defined value
3.59 to 22.5 mA 22.5 mA
Endress+Hauser