Configuring Metering Tones - AudioCodes MP-11x User Manual

User's Manual
26.2

Configuring Metering Tones

The FXS interfaces can generate 12/16 KHz metering pulses toward the Tel side (e.g., for
connection to a pay phone or private meter). Tariff pulse rate is determined according to
the device's Charge Codes table. This capability enables users to define different tariffs
according to the source/destination numbers and the time-of-day. The tariff rate includes
the time interval between the generated pulses and the number of pulses generated on
answer.
Notes:
•
The Metering Tones page is available only for FXS interfaces.
•
Charge Code rules can be assigned to routing rules in the Tel to IP Routing (see
'Configuring Tel to IP Routing' on page 256). When a new call is established, the
Tel to IP Routing is searched for the destination IP address. Once a route is
located, the Charge Code (configured for that route) is used to associate the route
with an entry in the Charge Codes table.

To configure Metering tones:
1. Open the Metering Tones page (Configuration tab > VoIP menu > GW and IP to IP >
Analog Gateway > Metering Tones).
2. Configure the Metering tones parameters as required. For a description of the
parameters appearing on this page, see 'Configuration Parameters Reference' on
page 475.
3. Click Submit to apply your changes.
4. To save the changes to the flash memory, see 'Saving Configuration' on page 366.
If you set the 'Generate Metering Tones' parameter to Internal Table, access the Charge
Codes Table page by clicking the Charge Codes Table
on configuring the Charge Codes table, see 'Configuring Charge Codes' on page 302.
Version 6.6
Figure 26-2: Metering Tones Page
301
26. Analog Gateway
button. For more information
MP-11x & MP-124