Channel Parameters; Voice Parameters - AudioCodes MP-11x User Manual

User's Manual
Parameter

44.10 Channel Parameters

This subsection describes the device's channel parameters.

44.10.1 Voice Parameters

The voice parameters are described in the table below.
Parameter
Web/EMS: Input Gain
[InputGain]
Web: Voice Volume
EMS: Volume (dB)
[VoiceVolume]
EMS: Payload Format
[VoicePayloadFormat]
Web: MF Transport Type
[MFTransportType]
Web: Enable Answer Detector
[EnableAnswerDetector]
Version 6.6
TelProfile_EnableAGC
TelProfile_ECNlpMode
TelProfile_DigitalCutThrough
TelProfile_EnableFXODoubleAnswer
TelProfile_CallPriorityMode
The parameter IpPreference parameter EnableVo.
Table 44-34: Voice Parameters
Defines the pulse-code modulation (PCM) input gain control (in
decibels). This parameter sets the level for the received (Tel-to-
IP) signal.
The valid range is -32 to 31 dB. The default is 0 dB.
Note: This parameter can also be configured in an IP Profile
and/or a Tel Profile.
Defines the voice gain control (in decibels). This parameter sets
the level for the transmitted (IP-to-Tel) signal.
The valid range is -32 to 31 dB. The default is 0 dB.
Note: This parameter can also be configured in an IP Profile
and/or a Tel Profile.
Determines the bit ordering of the G.726/G.727 voice payload
format.

[0] = (Default) Little Endian

[1] = Big Endian
Notes:

To ensure high voice quality when using G.726/G.727, both
communicating ends should use the same endianness format.
Therefore, when the device communicates with a third-party
entity that uses the G.726/G.727 voice coder and voice quality
is poor, change the settings of this parameter (between Big
Endian and Little Endian).

The G.727 coder is currently not supported by MP-124 Rev. E.
Currently, not supported.
Currently, not supported.
44. Configuration Parameters Reference
Description
Enable AGC
EC NLP
Mode
-
-
-
Description
555
EnableAGC
ECNLPMode
DigitalCutThrough
EnableFXODoubleAnswer
CallPriorityMode
MP-11x & MP-124