AudioCodes MP-11x User Manual page 228

Parameter
Web: Enable Early Media
[IpProfile_EnableEarlyMedia]
Web: Copy Destination Number to
Redirect Number
[IpProfile_CopyDest2RedirectN
umber]
Web: Media Security Behavior
[IpProfile_MediaSecurityBehavi
our]
Web: CNG Detector Mode
[IpProfile_CNGmode]
Web: Modems Transport Type
[IpProfile_VxxTransportType]
Web: NSE Mode
[IpProfile_NSEMode]
Web: Number of Calls Limit
[IpProfile_CallLimit]
Web: Progress Indicator to IP
[IpProfile_ProgressIndicator2IP]
Web: Profile Preference
[IpProfile_IpPreference]
Web: Coder Group
[IpProfile_CodersGroupID]
Web: Remote RTP Base UDP
Port
[IpProfile_RemoteBaseUDPPort
]
Web: First Tx DTMF Option
[IpProfile_FirstTxDtmfOption]
User's Manual
For a description, see the global parameter EnableEarlyMedia.
For a description, see the global parameter
CopyDest2RedirectNumber.
For a description, see the global parameter
MediaSecurityBehaviour.
For a description, see the global parameter CNGDetectorMode.
For a description, see the global parameters
V21ModemTransportType, V22ModemTransportType,
V23ModemTransportType, V32ModemTransportType, and
V34ModemTransportType.
For a description, see the global parameter NSEMode.
Defines the maximum number of concurrent calls (incoming and
outgoing). If the number of concurrent calls reaches this limit,
the device rejects any new incoming and outgoing calls
belonging to this IP Profile.
This parameter can also be set to the following:

[-1] = (Default) No limitation on calls.

[0] = Calls are rejected.
Note: For IP-to-IP calls, you can configure the device to route
calls to an alternative IP Group when this maximum number of
concurrent calls is reached. To do so, you need to add an
alternative routing rule in the Outbound IP Routing table that
reroutes the call to an alternative IP Group. You also need to
add a rule to the Reason for Alternative Routing table to initiate
an alternative rule for Tel-to-IP calls using cause 805.
For a description, see the global parameter
ProgressIndicator2IP.
Defines the priority of the IP Profile, where "1" is the lowest and
"20" the highest. If both IP and Tel Profiles apply to the same
call, the coders and other common parameters of the preferred
profile are applied to the call. If the preference of the Tel and IP
Profiles is identical, the Tel Profile parameters are applied.
Note: If the coder lists of both IP and Tel Profiles apply to the
same call, only the coders common to both are used. The order
of the coders is determined by the preference.
For a description, see the global parameter CodersGroup.
For a description, see the global parameter
RemoteBaseUDPPort.
For a description, see the global parameter TxDTMFOption.
228
MP-11x & MP-124
Description
Document #: LTRT-65432