AudioCodes MP-11x User Manual page 549

User's Manual
Parameter
Web/EMS: SIT Q850
Cause
[SITQ850Cause]
Web/EMS: SIT Q850
Cause For NC
[SITQ850CauseForNC]
Web/EMS: SIT Q850
Cause For IC
[SITQ850CauseForIC]
Web/EMS: SIT Q850
Cause For VC
[SITQ850CauseForVC]
Web/EMS: SIT Q850
Cause For RO
[SITQ850CauseForRO]
Out-of-Service (Busy Out) Parameters
Web/EMS: Enable Busy
Out
[EnableBusyOut]
Version 6.6
parameter) is set to a value other than the default, the
RTPOnlyMode parameter value is ignored.
Defines the Q.850 cause value specified in the SIP Reason header that
is included in a 4xx response when a Special Information Tone (SIT) is
detected on an IP-to-Tel call.
The valid range is 0 to 127. The default is 34.
Notes:

For mapping specific SIT tones, you can use the
SITQ850CauseForNC, SITQ850CauseForIC, SITQ850CauseForVC,
and SITQ850CauseForRO parameters.

This parameter is applicable only to FXO interfaces.
Defines the Q.850 cause value specified in the SIP Reason header that
is included in a 4xx response when SIT-NC (No Circuit Found Special
Information Tone) is detected from the TelPSTN for IP-to-Tel calls.
The valid range is 0 to 127. The default is 34.
Notes:

When not configured (i.e., default), the SITQ850Cause parameter is
used.

This parameter is applicable only to FXO interfaces.
Defines the Q.850 cause value specified in the SIP Reason header that
is included in a 4xx response when SIT-IC (Operator Intercept Special
Information Tone) is detected from the Tel for IP-to-Tel calls.
The valid range is 0 to 127. The default is -1 (not configured).
Notes:

When not configured (i.e., default), the SITQ850Cause parameter is
used.

This parameter is applicable only to FXO interfaces.
Defines the Q.850 cause value specified in the SIP Reason header that
is included in a 4xx response when SIT-VC (Vacant Circuit - non-
registered number Special Information Tone) is detected from the Tel
for IP-to-Tel calls.
The valid range is 0 to 127. The default is -1 (not configured).
Notes:

When not configured (i.e., default), the SITQ850Cause parameter is
used.

This parameter is applicable only to FXO interfaces.
Defines the Q.850 cause value specified in the SIP Reason header that
is included in a 4xx response when SIT-RO (Reorder - System Busy
Special Information Tone) is detected from the Tel for IP-to-Tel calls.
The valid range is 0 to 127. The default is -1 (not configured).
Notes:

When not configured (i.e., default), the SITQ850Cause parameter is
used.

This parameter is applicable only to FXO interfaces.
Enables the Busy Out feature.

[0] Disable (Default)
549
44. Configuration Parameters Reference
Description
MP-11x & MP-124