AudioCodes MP-11x User Manual page 462

3. Configure the test endpoint parameters as desired. See the table below for a
description of these parameters.
4. Click Submit to apply your settings.
Parameter
General Tab
Endpoint URI
[Test_Call_Endpoin
tURI]
Called URI
[Test_Call_CalledU
RI]
CLI: called-uri
Route By
[Test_Call_DestTyp
e]
IP Group ID
[Test_Call_IPGroup
ID]
Destination Address
[Test_Call_DestAd
dress]
Destination
Transport Type
[Test_Call_DestTra
nsportType]
Application Type
[Test_Call_Applicat
ionType]
User's Manual
Test Call Table Parameters
Defines the endpoint's URI. This can be defined as a user or user@host.
The device identifies this endpoint only by the URI's user part. The URI's
host part is used in the SIP From header in REGISTER requests.
The valid value is a string of up to 150 characters. By default, this parameter
is not configured.
Defines the destination (called) URI (user@host).
The valid value is a string of up to 150 characters. By default, this parameter
is not configured.
Defines the type of routing method. This applies to incoming and outgoing
calls.

[0] GW Tel2IP = (Default) Calls are matched by (or routed to) an SRD
and Application type (defined in the SRD and Application Type
parameters below).

[1] IP Group = Calls are matched by (or routed to) an IP Group ID.

[2] Dest Address = Calls are matched by (or routed to) an SRD and
application type.
Notes:

For REGISTER messages, the option [0] cannot be used as the routing
method.

For REGISTER messages, if option [1] is used, only Server-type IP
Groups can be used.
Defines the IP Group ID to which the test call is sent or from which it is
received.
Notes:

This parameter is applicable only if option [1] is configured for the 'Route
By' parameter.

This IP Group is used for incoming and outgoing calls.
Defines the destination host. This can be defined as an IP address[:port] or
DNS name[:port].
Note: This parameter is applicable only if the 'Route By' parameter is set to
[2] (Dest Address).
Defines the transport type for outgoing calls.

[-1] Not configured (default)

[0] UDP

[1] TCP

[2] TLS
Note: This parameter is applicable only if the 'Route By' parameter is set to
[2] (Dest Address).
Defines the application type for the endpoint.

[0] GW & IP2IP (default)
Description
462
MP-11x & MP-124
Document #: LTRT-65432