AudioCodes MP-11x User Manual page 568

Parameter
EMS: Relay Volume (dBm)
[FaxModemRelayVolume]
Web/EMS: Fax Bypass Output
Gain
[FaxBypassOutputGain]
Web/EMS: Modem Bypass Output
Gain
[ModemBypassOutputGain]
EMS: Basic Packet Interval
[FaxModemBypassBasicRTPPac
ketInterval]
EMS: Dynamic Jitter Buffer
Minimal Delay (dB)
[FaxModemBypasDJBufMinDela
y]
EMS: Enable Inband Network
Detection
[EnableFaxModemInbandNetwor
kDetection]
User's Manual
Defines the fax gain control.
The range is -18 to -3, corresponding to -18 dBm to -3 dBm in 1-
dB steps. The default is -6 dBm fax gain control.
Defines the fax bypass output gain control.
The range is -31 to +31 dB, in 1-dB steps. The default is 0 (i.e.,
no gain).
Defines the modem bypass output gain control.
The range is -31 dB to +31 dB, in 1-dB steps. The default is 0
(i.e., no gain).
Defines the basic frame size used during fax/modem bypass
sessions.

[0] = (Default) Determined internally

[1] = 5 msec (not recommended)

[2] = 10 msec

[3] = 20 msec
Note: When set to 5 msec (1), the maximum number of
simultaneous channels supported is 120.
Defines the Jitter Buffer delay (in milliseconds) during fax and
modem bypass session.
The range is 0 to 150 msec. The default is 40.
Enables in-band network detection related to fax/modem.

[0] = (Default) Disable.

[1] = Enable. When this parameter is enabled on Bypass
and transparent with events mode (VxxTransportType is set
to 2 or 3), a detection of an Answer Tone from the network
triggers a switch to bypass mode in addition to the local
Fax/Modem tone detections. However, only a high bit-rate
coder voice session effectively detects the Answer Tone sent
by a remote endpoint. This can be useful when, for example,
the payload of voice and bypass is the same, allowing the
originator to switch to bypass mode as well.
568
MP-11x & MP-124
Description
Document #: LTRT-65432