Configuring Call Waiting - AudioCodes MP-11x User Manual

User's Manual
Table 26-6: Caller ID Permissions Table Parameter Description
Parameter
Caller ID
[EnableCallerId_IsEnabled]

26.10 Configuring Call Waiting

The Call Waiting table allows you to enable or disable call waiting per FXS port.
Notes:
•
This page is applicable only to FXS interfaces.
•
You can enable or disable call waiting for all the device's ports using the global
parameter, 'Enable Call Waiting' in the Supplementary Services page
(Configuration tab > VoIP menu > GW and IP to IP > DTMF and
Supplementary > Supplementary Services).
•
The CPT file installed on the device must include a 'call waiting Ringback' tone
(caller side) and a 'call waiting' tone (called side, FXS interfaces only).
•
The EnableHold parameter must be enabled on both the calling and the called
sides.
•
For additional call waiting configuration, see the following parameters:
FirstCallWaitingToneID (in the CPT file), TimeBeforeWaitingIndication,
WaitingBeepDuration, TimeBetweenWaitingIndications, and
NumberOfWaitingIndications.
•
The Call Waiting table can also be configured using the table ini file parameter,
CallWaitingPerPort.

To enable call waiting per port:
1. Open the Call Waiting page (Configuration tab > VoIP menu > GW and IP to IP >
Analog Gateway > Call Waiting).
2. Configure the table as required. For a description of the parameter, see the table
below.
3. Click Submit to apply your changes.
Parameter
Call Waiting Configuration
Version 6.6
Enables Caller ID generation (FXS) or detection (FXO) per port.

[0] Disable

[1] Enable
Figure 26-9: Call Waiting Page
Table 26-7: Call Waiting Table Parameter Description
Enables call waiting for the port.
Description
Description
311
26. Analog Gateway
MP-11x & MP-124