User's Manual
Figure 2-7: MP-124 Serial Connection with PC for CLI Communication (e.g., MP-124 Rev. E)
2.
Establish serial communication with the device using a terminal emulator program
(such as HyperTerminal) with the following communication port settings:
•
Baud Rate: 115,200 bps for MP-124 and 9,600 bps for MP-11x
•
Data Bits: 8
•
Parity: None
•
Stop Bits: 1
•
Flow Control: None
3.
At the prompt, type the login username (default is "Admin" - case sensitive):
login: Admin
4.
At the prompt, type the password (default is "Admin" - case sensitive):
password: Admin
5.
At the prompt, type the following command to access the Configuration folder:
/>CONF
6.
View the current network settings, by typing the following command:
/CONFiguration>GCP IP
7.
Change the network settings, by typing the following command:
/CONFiguration>SCP IP <IP address> <subnet mask> <Default Gateway>
You must enter all three network parameters, each separated by a space, for
example:
/CONFiguration>SCP IP 10.13.77.7 255.255.0.0 10.13.0.1
8.
Save your changes and reset the device, by typing the following command:
/CONFiguration>SAR
Version 6.6
2. Assigning the OAMP IP Address
31
MP-11x & MP-124