Message Waiting Indication Parameters - AudioCodes MP-11x User Manual

User's Manual
Parameter
Web: NRT Retry
Subscription Time
EMS: NRT Subscription
Retry Time
[NRTSubscribeRetryTime]
Web/EMS: Call Forward
Ring Tone ID
[CallForwardRingToneID]
44.11.5.4

Message Waiting Indication Parameters

The message waiting indication (MWI) parameters are described in the table below.
Parameter
Web: Enable MWI
EMS: MWI Enable
[EnableMWI]
Web/EMS: MWI Analog Lamp
[MWIAnalogLamp]
Web/EMS: MWI Display
[MWIDisplay]
Web: Subscribe to MWI
EMS: Enable MWI Subscription
[EnableMWISubscription]
Version 6.6
Defines the Retry period (in seconds) for Dialog subscription if a
previous request failed.
The valid value range is 10 to 7200. The default is 120.
Defines the ringing tone type played when call forward notification is
accepted.
The valid value range is 1 to 5. The default is 1.
Table 44-45: MWI Parameters
Enables Message Waiting Indication (MWI).

[0] Disable (default).

[1] Enable
Notes:

This parameter is applicable only to FXS interfaces.

The device supports only the receipt of SIP MWI NOTIFY
messages (the device doesn't generate these messages).

For more information on MWI, see 'Message Waiting
Indication' on page 287.
Enables the visual display of MWI.

[0] Disable (default).

[1] Enable = Enables visual MWI by supplying line voltage
of approximately 100 VDC to activate the phone's lamp.
Notes:

This parameter is applicable only for FXS interfaces.

This parameter can also be configured in a Tel Profile.
Enables sending MWI information to the phone display.

[0] Disable = (Default) MWI information isn't sent to display.

[1] Enable = The device generates an MWI message
(determined by the parameter CallerIDType), which is
displayed on the MWI display.
Note:

This parameter is applicable only to FXS interfaces.

This parameter can also be configured in a Tel Profile.
Enables subscription to an MWI server.

[0] No (default)

[1] Yes
Notes:

To configure the MWI server address, use the MWIServerIP
parameter.

To configure whether the device subscribes per endpoint or
589
44. Configuration Parameters Reference
Description
Description
MP-11x & MP-124