Digit Collection And Dial Plan Parameters - AudioCodes MP-11x User Manual

User's Manual
Parameter

44.11.3 Digit Collection and Dial Plan Parameters

The digit collection and dial plan parameters are described in the table below.
Parameter
Web/EMS: Dial Plan Index
[DialPlanIndex]
[Tel2IPSourceNumberMappi
ngDialPlanIndex]
Web: Digit Mapping Rules
EMS: Digit Map Pat terns
[DigitMapping]
Version 6.6

[1] Nortel

[2] cisco

[3] threecom

[4] korea
Table 44-40: Digit Collection and Dial Plan Parameters
Defines the Dial Plan index to use in the external Dial Plan file. The
Dial Plan file is loaded to the device as a .dat file (converted using
the DConvert utility). The Dial Plan index can be defined globally or
per Tel Profile.
The valid value range is 0 to 7, where 0 denotes PLAN1, 1 denotes
PLAN2, and so on. The default is -1, indicating that no Dial Plan file
is used.
Notes:

If this parameter is configured to select a Dial Plan index, the
settings of the parameter DigitMapping are ignored.

If this parameter is configured to select a Dial Plan index from an
external Dial Plan file, the device first attempts to locate a
matching digit pattern in the Dial Plan file, and if not found, then
attempts to locate a matching digit pattern in the Digit Map rules
configured by the DigitMapping parameter.

This parameter can also be configured in a Tel Profile.

For more information on the Dial Plan file, see 'Dialing Plans for
Digit Collection' on page 376.
Defines the Dial Plan index in the external Dial Plan file for the Tel-
to-IP Source Number Mapping feature.
The valid value range is 0 to 7, defining the Dial Plan index [Plan x]
in the Dial Plan file. The default is -1 (disabled).
For more information on this feature, see Modifying ISDN-to-IP
Calling Party Number.
Defines the digit map pattern. If the digit string (i.e., dialed number)
matches one of the patterns in the digit map, the device stops
collecting digits and establishes a call with the collected number.
The digit map pattern can contain up to 52 options (rules), each
separated by a vertical bar (|). The maximum length of the entire digit
pattern is 152 characters. The available notations include the
following:

[n-m]: Range of numbers (not letters).

. (single dot): Repeat digits until next notation (e.g., T).

x: Any single digit.

T: Dial timeout (configured by the TimeBetweenDigits parameter).

S: Short timer (configured by the TimeBetweenDigits parameter;
default is two seconds) that can be used when a specific rule is
defined after a more general rule. For example, if the digit map is
44. Configuration Parameters Reference
Description
Description
575 MP-11x & MP-124