Snmp-Based Management; Configuring Snmp Community Strings - AudioCodes MP-11x User Manual

User's Manual
6

SNMP-Based Management

The device provides an embedded SNMP Agent to operate with a third-party SNMP
Manager (e.g., element management system or EMS) for operation, administration,
maintenance, and provisioning (OAMP) of the device. The SNMP Agent supports standard
Management Information Base (MIBs) and proprietary MIBs, enabling a deeper probe into
the interworking of the device. The SNMP Agent can also send unsolicited events (SNMP
traps) towards the SNMP Manager. All supported MIB files are supplied to customers as
part of the release.
This section provides configuration relating to SNMP management.
Note:
SNMP User's Guide.
6.1

Configuring SNMP Community Strings

The SNMP Community String page allows you to configure up to five read-only and up to
five read-write SNMP community strings and to configure the community string that is used
for sending traps.
For detailed descriptions of the SNMP parameters, see 'SNMP Parameters' on page 490.

To configure the SNMP community strings:
1. Open the SNMP Community String page (Configuration tab > System menu >
Management submenu > SNMP submenu > SNMP Community String).
2. Configure the SNMP community strings parameters according to the table below.
3. Click Submit to apply your changes.
4. To save the changes to flash memory, see 'Saving Configuration' on page 366.
Version 6.6
For more information on SNMP support such as SNMP traps, refer to the
87
6. SNMP-Based Management
MP-11x & MP-124