Configuring Charge Codes - AudioCodes MP-11x User Manual

26.3

Configuring Charge Codes

The Charge Codes table is used to configure the metering tones (and their time interval)
that the FXS interfaces generate to the Tel side. To associate a charge code to an
outgoing Tel-to-IP call, use the Tel to IP Routing.
You can configure up to 25 different charge codes, where each table row represents a
charge code. Each charge code can include up to four different time periods in a day (24
hours). The device selects the time period by comparing the device 's current time to the
end time of each time period of the selected Charge Code. The device generates the
Number of Pulses on Answer once the call is connected and from that point on, it
generates a pulse each Pulse Interval. If a call starts at a certain time period and crosses
to the next, the information of the next time period is used.
Notes:
•
The Charge Codes Table page is available only for FXS interfaces.
•
The Charge Codes table can also be configured using the table ini file parameter,
ChargeCode.

To configure the Charge Codes:
1. Open the Charge Codes Table page (Configuration tab > VoIP menu > GW and IP
to IP submenu > Analog Gateway submenu > Charge Codes). Alternatively, you can
access this page from the Metering Tones page (see 'Configuring Metering Tones' on
page 301).
2. Configured the charge codes, as required. For a description of the parameters, see
the table below.
3. Click Submit to apply your changes.
4. To save the changes to the flash memory, see 'Saving Configuration' on page 366.
User's Manual
Figure 26-3: Charge Codes Table Page
302
MP-11x & MP-124
Document #: LTRT-65432