Working With Tables - AudioCodes MP-11x User Manual


To save configuration changes on a page to the device's volatile memory (RAM),
do one of the following:

On the toolbar, click the Submit

At the bottom of the page, click the Submit
When you click Submit, modifications to parameters with on-the-fly capabilities are
immediately applied to the device and take effect. Parameters displayed on the page with
the lightning
'Resetting the Device' on page 363.
Note: Parameters saved to the volatile memory (by clicking Submit), revert to their
previous settings after a hardware or software reset, or if the device is powered down.
Therefore, to ensure parameter changes (whether on-the-fly or not) are retained,
save ('burn') them to the device's non-volatile memory, i.e., flash (see 'Saving
Configuration' on page 366).
If you enter an invalid parameter value (e.g., not in the range of permitted values) and then
click Submit, a message box appears notifying you of the invalid value. In addition, the
parameter value reverts to its previous value and is highlighted in red, as shown in the
figure below:
4.1.6.4

Working with Tables

This section describes how to work with configuration tables, which are provided in basic or
enhanced design, depending on the configuration page.
User's Manual
symbol take effect only after a device reset. For resetting the device, see
Figure 4-10: Value Reverts to Previous Valid Value
button.
button.
48
MP-11x & MP-124
Document #: LTRT-65432