Disassembling Front Axle - wsm L3301 Workshop Manual

L3301, L3901, L4701, WSM

(2) Disassembling Front Axle

[A] 2WD Model
Front Wheel Hub
1. Remove the front wheel hub cap (1).
2. Draw out the cotter pin.
3. Remove the slotted nut (2).
4. Remove the collar.
5. Remove the front wheel hub (3) with a puller.
(When reassembling)
• Replace cotter pin with a new one.
• Fill grease in the clearance between knuckle arm shaft (4) and
spacer (6).
• Be sure to attach oil seal (5) pointing lip face outside.
IMPORTANT
• After tightening the slotted nut to the specified torque,
insert a cotter pin and bend it as shown in the figure.
Tightening torque Front wheel hub slotted nut
(1) Front Wheel Hub Cap
(2) Slotted Nut
(3) Front Wheel Hub
6-S12
FRONT AXLE
49 to 68 N·m
5.0 to 7.0 kgf·m
37 to 50 lbf·ft
(4) Knuckle Arm Shaft
(5) Oil Seal
(6) Spacer
9Y1211012FAS0013US0
KiSC issued 09, 2016 A